Movers and Riggers of Machinery
ChrisCo Machinery, Inc. has been moving and rigging machinery for over 27 years. We have the right equipment and engineers to get the job done safely and in a reasonable amount of time.
ChrisCo Machinery, Inc. can assist you with all of your plant needs: machinery relocation for LEAN, plant relocation, machinery installation, and machinery removal.
If it is one machine or several hundred ChrisCo Machinery, Inc. can do the job.
We have fork lifts (approx. 25) in a range of 4000 lbs. to 35,000 lbs. cap.
We have (2) road tractors (80,000 lbs. cap) and (1) straight truck (54000 Lbs. cap.)
Our trailers consist of (3) van, (2) flat beds-(1) 48' spread axle ,and (1) 48'-close tandem.
Specialty trailers are (1) 48' step deck w/ hyd. tail, and (1) 53' step deck Landoll
We can haul w-i-d-e loads in NC, VA, SC, TN, GA, AL, WVA, PA, OH, IN, KY
There is no job to BIG or to small
Over 200 customers served in the last year.
Here is few of our Satisfied Customers:
Stanley Furniture, Hooker Furniture, Basset Furniture, Industrial Wood Products, Endura Products,
Vaughan Furniture, Lexington Furniture, Mobel Inc., Atlanta Hardwoods Corporation,
Carolina Drawers, Frank Chervan, Rubber Mill, This End Up, Cambium International,
Cleoria Sterling, Curve Makers, Rouge Valley Door, Specialty Woods Inc., Blandy Hardwoods,
Fegerson Woodworking, Clounch Industries, Trinity Furniture, Moslow Wood Products,Inc.,
Union Grove Moulding & Millwork Inc., United Sprinkler Co,Inc., Middleton Lumber Co.,
Virginia Sterling Furniture, N. C. Moulding Company, Industrial Recovery Services, Inc.,
Swaim-Wagner Furniture, Vaughn Bassett, Dubois Wood Products, Evans Cabinet Corporation
RT Machine, J & G Machinery, Pruitt Machinery, Johnson Machinery Sales, Tannewitz Inc.,
South State Machinery, Ex Factory Inc.,
Below are some examples of jobs completed in the past:
Sorry I do not have more pics but I am always to busy working to stop and take a pic.
(2) Bell forestry machines with tires loaded into one 40' container
A Large John Deere 648G Skidder with tires loaded into a 40' container (there was less than a 1/16" clearance on all sides)
Here we assembled (12) bins mfg. by Keith walking floors, each bin was 4' wide and 40' long
This was a challenge because we had to carry the walls of the bins through the plant making many tight turns (with the wall only 1-1/2" thick and 40' long they were not very stable)
Job was completed ahead of schedule and with no problems!
Removal of a Timesaver 3 head wide belt sander from the second floor of a plant.
Examples of Some loaded equipment
A complete Shoda Twin Table Router load on (1) truck
Torwegge Double Sided Tenoner
Over 475' of 36" dust pipe
Taylor RF gluer 10' wide load
Back to ChrisCo Machinery Home Page